Product ID:KEL-GUARD EPOXY ENAMEL PART 2, 1790-002
MSDS Date:07/12/1991
FSC:8010
NIIN:00N058103
Kit Part:Y
MSDS Number: BWZGS

KELLY-MOORE PAINT CO INC

1015 COMMERCIAL ST
SAN CARLOS, CA 94070
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 415-592-8337

Preparer: JULIAN E. SCHAFER

Cage: 0BBH6

KELLY-MOORE PAINT CO INC

SAN CARLOS, CA 94070 US

Telephone: 415-592-8337

Cage: 0BBH6

BISPHENOL A-EPICHLOROHYDRIN COPOLYMER; (BISPHENOL-A,

CAS: 25068-38-6

RTECS: SL6475000

Fraction By Weight: 50-60%

OSHA PEL N/K

ACGIH TLV: N/K

ETHANOL, 2-PROPOXY-; (ETHYLENE GLYCOL, PROPYL ETHER).

CAS: 2807-30-9

RTECS: KM2800000

Fraction By Weight: 40-50%

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:DIZZINESS, HEADACHE, NAUSEA,
CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, UNCONSCIOUSNESS,
SKIN & EYE IRRITATION. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING & INHALING CONTENTS MAY BE HARMFUL OR FATAL.
CHRONIC:PROLONGED EXPOSURE TO HIGH VAPOR CONCENTRATIONS MAY RESULT
IN (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:KIDNEY OR LIVER DAMAGE. REPORTS HAVE
ASSOCIATED REPEATED & PROLONGED OCCUPATIONAL OVEREXPOSURE TO
SOLVENTS W/PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE.
Medical Cond Aggravated by Exposure:SEE YOUR PHYSICIAN FOR SPECIFIC
MEDICAL OPINION REGARDING YOUR CONDITION.

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT MD.
EYE:FLUSH W/LARGE VOLUMES OF WATER FOR AT LEAST 15 MINUTES. GET
MEDICAL ATTENTION. SKIN:WIPE OFF W/RAG. WASH THOROUGHLY W/SOAP &
WATER. INGEST :DO NOT INDUCE VOMITING. IF VOMITING OCCURS
SPONTANEOUSLY, KEEP HEAD BELOW HIPS TO PREVENT ASPIRATION OF LIQUID
INTO LUNGS. CONSULT HOSPITAL EMERGENCY ROOM OR POISON CONTROL
CENTER IMMEDIATELY.

Flash Point:120F,49C
Lower Limits:1.3%
Extinguishing Media:USE APPROVED CLASS B FIRE EXTINGUISHER OR
EXTINGUISHING AGENTS SUCH AS CO*2, FOAM, ETC.
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP .
WATER MAY BE USED TO COOL CLSD CNTNR TO PVNT PRESS BUILDUP. WATER
SPRAY/WATER FOG SHOULD BE USED (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, ELEC EQUIP, SPKS & OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN
EXPOS TO EXTREME HEAT. DO NOT APPLY TO HOT (SUPP DATA)

Spill Release Procedures:EXTINGUISH ALL SOURCES OF IGNITION. VENTILATE
AREA TO PREVENT BUILDUP OF VAPORS THAT MAY ACCUMULATE IN LOW AREAS.
FOR LARGER SPILLS, DIKE AREA W/ABSORBENT MATERIAL & SCOOP UP
W/NON-SPARKING TOOLS. SOA K UP SMALL SPILLS W/ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
AWAY FROM SOURCES OF HEAT & FLAME.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:USE NIOSH/MSHA APPRVD PARTICLE MASK (TC-21C) TO
AVOID BRTHG SPRAY MIST/SANDING DUST IF LOC VENT IS ADEQ TO KEEP TLV
W/IN ACCEPT LIMS. IF LOC VENT IS NOT SUFFICIENT/WHERE EXPOS LIMS
ARE EXCEEDED, WEAR SUITABLE PROPERLY FITTED NIOSH/ (SUPDAT)
Ventilation:LOCAL EXHAUST SUFFICIENT TO KEEP TLV BELOW PRESCRIBED
LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIRE FIGHT PROC:CAREFULLY IN FIRE FIGHTING. THIS PROD WILL FLOAT ON
WATER & CAN BE IGNITED ON WATER SURF. EXPLO HAZ:SURFS. VAPS MAY
TRAVEL ALONG GROUND & BE IGNITED AT DIST LOCATIONS W/POSS FLASHBACK
TO HNDLG SITE. RESP PROT:MSHA APPRVD RESP (TC-23C/BETTER) FOR
ORGANIC VAPORS W/DUST FILTER AS NEEDED.

Boiling Pt:B.P. Text:>240F,>116C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.2-1.44
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:60-70

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HIGH TEMPERATURES, IGNITION SOURCES.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION/COMBUSTION AS IN WELDING OR FIRE.

Waste Disposal Methods:DISPOSE OF I/A/W LOCAL, STATE & FEDERAL
REGULATIONS. INCINERATE IN APPROVED FACILITY, BUT NOT IN CLOSED
CONTAINER.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.